Brother HL-1000 Series Podręcznik szybkiej konfiguracji - Strona 25

Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Drukarka Brother HL-1000 Series. Brother HL-1000 Series 42 stron. Brother hl-1040: quick setup

Drukuj stronę

Other Control Features

Sleep Mode

When the printer does not receive data for a certain period of time (time-out), it enters

sleep mode. Sleep mode acts as though the printer was turned off. The default time-out

is 5 minutes. While the printer is in sleep mode, all the lamps are off and it is as if it

was turned off, but the printer can still receive data from the computer. Receiving a print

file or document automatically wakes up the printer to start printing. Pressing the switch

also wakes up the printer.

Note

When the printer goes into sleep mode, the fan will not stop until the printer engine

has cooled down.

Sleep mode allows the print engine to cool, so the temperature of your room and how

long the printer has been in sleep mode affects the warm-up time. This warm-up time

can take up to 30 seconds. The Ready lamp blinks to indicate that the printer is

warming up.

You can change the time out for the sleep mode with the supplied printer driver (all

models) or Remote Printer Console program (HL-1040/1050 only). Refer to the Help

section in the printer driver or RPC program for more information about the sleep

mode setting.

Test Print Mode

The printer has the following test print mode. Follow these steps:

1. Make sure that the top cover is closed.

2. Hold down the switch and turn on the power switch. Keep the switch depressed

until the Drum lamp comes on.

The Drum lamp lights to indicate that the printer is in the test print mode.

3. Press the switch again to execute the test print or hold down the switch to select

another option and release the switch to execute the selected option.

The test print mode varies depending upon the printer model as follows:

Lamp Lit Choice

Drum

Test sample

page

Alarm

Print Config

& Print Fonts I

Ready

Factory Reset The printer is restored to the factory setting and permanent

Data

Hex Dump

Function

The printer prints a test sample page.

The printer returns to the ready status after printing.

The printer prints the current configuration of the printer

and a list of the internal fonts.

The printer returns to the ready status after printing.(HL-

1040/1050 only)

fonts and macros are cleared.

The printer returns to the ready status after printing.(HL-

1040/1050 only)

The printer can print data as hexadecimal values, so that

you can check data errors and problems. To exit from this

mode, you have to turn off the printer. (HL-1040/1050

only)

- 23 -