Fujitsu Lifebook B3020 Bios Manual - Strona 6

Przeglądaj online lub pobierz pdf Bios Manual dla Laptop Fujitsu Lifebook B3020. Fujitsu Lifebook B3020 29 stron. Lifebook b series
Również dla Fujitsu Lifebook B3020: Bios Manual (38 strony)

Drukuj stronę
Fujitsu Lifebook B3020 Bios Manual
L i f e B o o k B S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA/
ATAPI devices are installed.
Main
Type:
Total Sectors::
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
Transfer Mode:
Ultra DMA Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
n
Type:
Auto
n
None
n
CD-ROM
n
Hard Disk
LBA Format
Total Sectors:
___
Maximum
___
Capacity:
CHS Format
n
Cylinders:
A number between
0 and 65,535
6
PhoenixBIOS Setup Utility
Advanced
Security
Primary Master [TOSHIBA MK4025GAS-(PM)]
[Auto]
LBA Format
78140160
40008MB
[16 Sectors]
[Enabled]
[Multiword DMA 2]
[Disabled]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
[Auto]
___
___
–—
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may or may not be displayed.
Power
Boot
Info
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
Select
Sub-Menu
Description
Selects the ATA/ATAPI device type. Select Auto to have the type auto-
matically identified by the BIOS at POST. If None is selected, all of the
following Set-up items do not appear. Select CD-ROM if a CD-ROM
drive is installed at this connection. If Hard Disk is selected, you must
specify the number of Cylinders, Heads, and Sectors for the drive.
Logical Block Addressing (LBA)
The total number of sectors on your hard disk
The maximum capacity of your hard disk
Cylinders/Heads/Sectors
This item is active only when Hard Disk is selected as the type. This
field is changed by incrementing (pressing the [Spacebar]), by typing in
the number, or using the "+" and "-" keys.
Exit
F9
Setup Defaults
F10
Save and Exit