AEG L 75283 FL Podręcznik użytkownika - Strona 25
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz AEG L 75283 FL. AEG L 75283 FL 32 stron.
Problem
There is water on
the floor.
You cannot open
the appliance
door.
The appliance
makes an unusual
noise.
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
Possible cause
You did not press button
4
.
The delay start is set.
The Child Lock function
is activated.
Leakages from the cou-
plings of the water ho-
ses.
Leakages from the drain
pump.
The water drain hose is
damaged.
The washing programme
is in operation.
There is water in the
drum.
Incorrect level of the ap-
pliance.
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
Possible solution
Press button
To start immediately the pro-
gramme, cancel the delay start.
Deactivate the Child Lock func-
tion.
Make sure that the couplings are
tight.
Make sure that the drain pump
filter is tight.
Make sure that the water inlet
hose has no damages.
Let the washing programme end.
Set the drain or the spin pro-
gramme.
Adjust the level of the appliance.
Refer to 'Installation'.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
ENGLISH
25
.
4