Brother P-Touch PT-E550WNIVP Podręcznik szybkiej konfiguracji - Strona 30

Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Urządzenie do tworzenia etykiet Brother P-Touch PT-E550WNIVP. Brother P-Touch PT-E550WNIVP 49 stron.

Drukuj stronę

GETTING STARTED

Alkaline/Ni-MH Battery

After making sure that the power is off, remove the rear cover

on the back of the P-touch labeling system. If the batteries

are already in the P-touch labeling system, remove them.

Make sure that the power is turned off when replacing

batteries.

Insert six new AA-size alkaline batteries (LR6), or fully

charged Ni-MH rechargeable batteries (HR6). Make sure

that the positive (+) and negative (-) ends of the batteries

match the positive (+) and negative (-) marks inside the

battery compartment.

Users of alkaline batteries

Always replace all six batteries at the same time using brand

new ones.

Users of Ni-MH rechargeable batteries

Always replace all six batteries at the same time with fully

charged ones.

Visit us at support.brother.com for the latest information

about recommended batteries.

Attach the rear cover by inserting the three hooks at the

bottom into the slots on the P-touch labeling system, then

pushing down firmly until it snaps into place.

• Remove the batteries if you do not intend to use the P-touch labeling system for an extended

period of time.

• Dispose of the battery at an appropriate collection point, not in the general waste stream. In

addition, be sure to observe all applicable regulations.

• When storing or discarding the battery, wrap it (for example with

cellophane tape), to prevent it from short-circuiting.

(Battery insulation example)

1. Cellophane tape

2. Alkaline or Ni-MH battery

Power Supply