AEG L61470WDBI Podręcznik użytkownika - Strona 17
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz AEG L61470WDBI. AEG L61470WDBI 40 stron.
Również dla AEG L61470WDBI: Podręcznik użytkownika (36 strony)
10.9 Opening the door
When the appliance is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press button Start/Pause to set
the machine to pause.
If the indicator Door after a few minutes
goes off, the door can be opened.
If the indicator Door stays on and the
door remains locked, this means that the
appliance is already heating or that the
water level is too high. In this case the
door cannot be opened.
If you cannot open the door but you
need to open it, turn the programme dial
to
to switch the appliance off. After a
few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button Start/Pause to start
the programme again.
10.10 At the end of the
programme
The appliance stops automatically. The
indicator of button Start/Pause, the
indicators Washing and Door go off. A
blinking
If you have set a programme or an
option that ends with water in the tub,
11. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
11.1 Drying setting
The recommended load size
is 3 kg for cottons and linen,
and 2 kg for synthetic items.
You can also to dry up to 4
kg of cotton items (see the
«Drying Programme » table).
will appear on the display.
the indicator Door remains on. The door
is locked. The water must be emptied
out before opening the door. During this
time the drum continues to turn at
regular intervals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
.
• Set the DRAIN or SPIN programme.
• Reduce the spin speed, if needed.
• Press button Start/Pause.
• When the programme has finished
the display shows a blinking
indicator Door goes off. The door can
be opened.
Turn the programme selector dial to
to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
10.11 Stand by
Once the programme has finished, after
few minutes the energy saving system
will be enable. The brightness of the
display is reduced. By pressing any
button the appliance comes out from the
energy saving status.
WARNING!
Open the water tap. Put
the drain hose in the sink
or connect to the drain
pipe.
1. Load the laundry one item at a time.
2. Turn the programme dial to the
programme applicable for the items
to dry (cottons or synthetics).
ENGLISH
17
. The