Fujitsu ETERNUS DX Disk Podręcznik konfiguracji - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Serwer Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 31 stron. Server connection, fcoe for linux driver settings for converged network adapter cards
Również dla Fujitsu ETERNUS DX Disk: Podręcznik użytkownika (35 strony), Podręcznik użytkownika (42 strony), Podręcznik konfiguracji (28 strony), Podręcznik konfiguracji (44 strony), Podręcznik konfiguracji (28 strony), Podręcznik konfiguracji (29 strony), Podręcznik konfiguracji (25 strony), Podręcznik konfiguracji (32 strony), Podręcznik konfiguracji (35 strony), Podręcznik konfiguracji (43 strony), Podręcznik konfiguracji (21 strony), Podręcznik konfiguracji (24 strony)

Drukuj stronę

Fujitsu ETERNUS DX Disk Podręcznik konfiguracji

Chapter 3

Notes

3.3

SAS Card Driver Notes

3.3

SAS Card Driver Notes

When the same type of chip is used for both the SAS card and the server's onboard RAID or RAID card, the

•

driver installed for the SAS card may also control the onboard RAID or RAID card.

Contact the server vendor for details of how each onboard RAID or RAID card is affected by the SAS card

driver.

The ETERNUS Multipath Driver supports path redundancy control (path fail-over).

•

For product information, refer to the following URL:

http://www.fujitsu.com/global/products/computing/storage/software/eternus-mpd/

3.4

Notes about Driver for ETERNUS DX Storage Systems

When connecting the server to the ETERNUS DX with multipath configuration, using the path redundancy

control (path fail-over) function with a driver for ETERNUS DX storage systems, one of the following drivers is

required by the server:

Windows Server

For product information, refer to the following URL:

http://www.fujitsu.com/global/products/computing/storage/software/eternus-mpd/

Even when single-path connection is used between the ETERNUS DX and server, an ETERNUS DX compatible

driver (ETERNUS device driver) is not required.

3.5

MSCS and WSFC Notes

To use MSCS or WSFC configuration, install either the driver for ETERNUS DX storage systems or the stand-

•

ard multipath driver (msdsm) for Windows Server

Windows Server

then check the connections before MSCS or WSFC installation.

Check the registry values by following the instructions in

•

(page

25), after installing MSCS or WSFC.

When setting up the MSCS, a reset group must be set for the ETERNUS DX. A reset group does not need to

•

be set for WSFC.

2019

2016

2012 R2

2012

2008 R2

2008

2012, Windows Server

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (SAS) for Windows

Driver

ETERNUS Multipath Driver

2019, Windows Server

2008 R2 or Windows Server

"Chapter 8 Checking the Registry Information"

2016, Windows Server

2008 on each node (server), and

P3AM-3442-18ENZ0

2012 R2,