Fujitsu PRIMEQUEST 1000 Series Podręcznik platformy sprzętowej - Strona 35

Przeglądaj online lub pobierz pdf Podręcznik platformy sprzętowej dla Serwer Fujitsu PRIMEQUEST 1000 Series. Fujitsu PRIMEQUEST 1000 Series 50 stron. Operation for solaris 10 operating system
Również dla Fujitsu PRIMEQUEST 1000 Series: Podręcznik dla początkujących (8 strony)

Drukuj stronę

Fujitsu PRIMEQUEST 1000 Series Podręcznik platformy sprzętowej

The support ranges of takeover form are the following ranges.

PRIMECLUSTER

MAC

IP+ MAC

Caution

Using over operation management LAN (LAN used for cluster operation management view) cannot be

supported.

4.5.2 Cluster Environment Setup Procedure

Set up the cluster environment in the same way as for the other LAN driver, follow "Setting up the

Network" in the "PRIMECLUSTER manual". Note that the secondary LAN port (fjgi interface) resource

name is "fjgi".

4.5.3 Notes in Cluster Environment

Please use "PRIMECLUSTER 4.1 or later" for a cluster system to use fjgi interface. If an earlier version of

cluster system is used, fjgi interface cannot be used for private LAN nor for IP address fail-over on public

LAN.

When using fjgi interface as the cluster interconnect, please perform the following command before initial

composition setup.

# ifconfig fjgi* plumb <Return>

* is instance-number

Then, please execute the following command and check that a MTU size of fjgi interface is not 9000byte

(JumboFrame is not set up).

# ifconfig fjgi* <Return>

* is instance-number

GigabitEthernet in a JumboFrame function cannot be used to the cluster interconnect.

GigabitEthernet as VLAN interface cannot be used to the cluster interconnect.

1:n operation standby mode

Mutual standby mode

TCP/IP communication

Using to the cluster interconnect (PRIMECLUSTER). (But, using in a JumboFrame or as

VLAN interface can not be performed)

Taking over form

Support

Not Supported

(Supported V4.1A10 or later)

Not Supported

(Supported V4.1A10 or later)