Fujitsu PRIMERGY BX600 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Serwer Fujitsu PRIMERGY BX600. Fujitsu PRIMERGY BX600 13 stron.

Drukuj stronę

Turning off the power and installing optional devices

Install optional devices to be installed after OS installation, such as a UPS device.

��

"Chapter 7 Installing Internal Options"

Check that no medium is inserted in the

floppy disk drive or CD-ROM drive.

Exit the operating system (OS).

After the OS is exited, the server is automatically

turned off. When the power of the server blade

is not off after the OS is exited, press the power

switch on the front of the server blade.

Press the main power switch on front

of the chassis.

Continue pressing the switch until main LED of

the chassis turns off.

Power off the peripheral devices, such

as the display.

Install the optional devices.

Hints for error handling

In preparation of a failure occurring, set the following:

��

"Chapter 5 Operations after OS Installation"

- Set to collect memory dump

By setting to collect memory dump, debugging information can be saved when a STOP error (blue screen) or a hangup occurs

in the system. Saving the debugging information helps to analyze the cause of the error.

- Create a system restoration disk.

When the system file or system environments are damaged, the system can be reconfigured with the content saved in the system

restoration disk.

- Store system settings

By storing the BIOS settings, the original information can be recovered when the setting information is lost.

When this server is installed, record and save the BIOS settings by yourself.

Be careful not to lose the stored BIOS setting information, as you must provide this in maintenance.

When the settings are completed, make sure to check notes before operation.

��

"5.5 Notes Before Operating the Server"

For details about maintenance after operations have started, refer to "User's Guide Chapter 9 Operation and Maintenance".

- After optional devices are installed, set the VLAN of

the network blade, BIOS Setup Utility as required.

For details about setting procedures, refer to

"PRIMERGY BX600 LAN Switch Blade Document CD",

"User's Guide Chapter 8 Hardware Configuration/

Utilities", or the option's manual.

- After UPS is installed, set the BIOS Setup Utility as

required. For details about setting procedures, refer to

"User's Guide 5.5.4 Notes on Advanced Uninterruptible

Power Supply (UPS)".

- When turning on the server again after turning it off,

wait for at least ten seconds and then press the

power switch. If the server is turned on straight after

being turned off, an error will occur that may cause

damage.

- If removing the server blade from the chassis, or

removing the power cable of the chassis after turning

off the server blade, wait for about 20 seconds

before performing the operation.