Fujitsu Primergy RX100 S3 Dodatkowa instrukcja serwisowa - Strona 24
Przeglądaj online lub pobierz pdf Dodatkowa instrukcja serwisowa dla Serwer Fujitsu Primergy RX100 S3. Fujitsu Primergy RX100 S3 45 stron.
Również dla Fujitsu Primergy RX100 S3: Instrukcja obsługi (9 strony)
Drukuj stronę
Replacing the riser card
Figure 8: Removing the riser card holder
Ê Loosen the two knurled screws (see circles).
Ê Remove the riser card holder by pulling upward from the system board.
Ê If controllers have been installed in the PCI slots of the riser card, remove
them (for a detailed description see the Options Guide).
Ê Install the controllers in the PCI slots of the new riser card.
Ê Plug the riser card into the PCI slot of the system board.
Ê Fasten the riser card holder with two knurled screws to the housing's rear
side.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
24
Service Supplement
Replacement routines
RX100 S3