Fujitsu C150-E194-01EN Instrukcja obsługi - Strona 29
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Skaner Fujitsu C150-E194-01EN. Fujitsu C150-E194-01EN 40 stron. Image scanner
Drukuj stronęClean the automatic document feeder through the following procedure (see the figure
on the next page for location):
1) Open the automatic document feeder by pulling it toward you while raising the
cover open lever.
2) Clean the following components with a dry cloth or a cloth moistened with cleaner
Pad
Glass surface,
White sheet
surface
Pick roller,
Facing roller,
Feed roller
Eject roller
*1: Be sure to open the automatic document feeder when the operator panel display
indicates other than "P" or "0". While the display indicates "P" or "0", the eject
roller does not rotate even if you press the round buttons.
4-4
F1 or isopropyl alcohol:
Clean the pad downward (in arrow direction) with a cloth
moistened with cleaner F1 or isopropyl alcohol.
In this case, be careful not to catch the cloth in the pick arm
or spring.
Clean these surfaces gently with a dry cloth.
Gently clean the surface of these rollers with a cloth
moistened with cleaner F1 or isopropyl alcohol, while
rotating the roller by fingers.
If many foreign matters stick to the roller, the roller
becomes slippery; therefore, thoroughly clean it.
Clean the roller while rotating the roller with power on.
1.With power on, open the automatic document feeder by
pulling it toward you while raising the cover open lever.
(*1)
2.Pressing the two round buttons on the operator panel at
the same time causes the eject roller to rotate little by
little.
3.Gently clean the surface of the roller with a cloth
moistened with cleaner F1 or isopropyl alcohol, while
rotating the roller with the cloth pressed against the
surface of the roller. (As a guideline, the eject roller
rotates one revolution every seven presses.)
If many foreign matters stick to the roller, the roller
becomes slippery; therefore, thoroughly clean it.
fi-4110CU Image Scanner Operator's Guide