5. Click [INSTALL PRODUCTS], and then click
[ISIS Driver].
6. Error Recovery Guide Installation dialog box
appears.
Error Recovery Guide is an application with
which you can view on-screen information for
troubleshooting errors that may occur in the
scanner. This guide helps solve problems, so
select [Yes] to install it. You may also choose
to install it later.
After you select [Yes] for installing Error
ATTENTION
Recovery Guide, the [Choose Setup Lan-
guage] dialog box appears. Select a lan-
guage and follow the on-screen
instructions. The Error Recovery Guide
dialog box is automatically displayed when
the installation is complete. Wait until the
installation of the ISIS starts.
7. Select a language for the installation on the
[Choose Setup Language] dialog box, and then
click the [Next] button.
8. Install the driver, following the on-screen
instructions.
9. When you see the [InstallShield Wiizard Com-
plete] dialog box, click the [Finish] button.
8
Your computer will restart and detect the scanner. Do
not remove the Setup CD-ROM from the CD drive until
your personal computer completely starts up again.
Depending on the operating system you
ATTENTION
are using, you may need to do the follow-
ing.
Windows 2000:
If you see the [Digital Signature not
Found] dialog box, click [Yes].
Windows Vista:
If you see the [Found New Hardware] dia-
log box, select [Locate and install driver
software], and then in the [User Account
Control] dialog box, click the [Continue]
button, if it is displayed.
The installation of FUJITSU ISIS is complete.
Next, install ScandAll PRO.
To make sure that FUJITSU ISIS is suc-
ATTENTION
cessfully installed, perform a scan with a
TWAIN-compliant application such as
ScandAll PRO. For information about how
to scan with ScandAll PRO, refer to sec-
tion 2.4 "Checking Scanner Driver Opera-
tion" on page 11.
ScandAll PRO
■ Installing ScandAll PRO
ScandAll PRO is software for scanning images, which is
in conformity with both TWAN/ISIS standards. Using
FUJITSU TWAIN 32 or FUJITSU ISIS together with
ScandAll PRO allows you to create document images.
Be sure to log on as a user with "Adminis-
ATTENTION
trator" privileges.
1. Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK START UP SCREEN>
appears.
2. Click [INSTALL PRODUCTS], and then click
[ScandAll PRO].
3. Select a language for the installation on
[Choose Setup Language] dialog box, and then
click the [OK] button.
Drukuj stronę