Brother MFC-820CW Podręcznik szybkiej konfiguracji - Strona 36
Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Faks Brother MFC-820CW. Brother MFC-820CW 45 stron. Quick setup guide - english
Również dla Brother MFC-820CW: Podręcznik szybkiej konfiguracji (45 strony), Instrukcja serwisowa (11 strony)
Drukuj stronę
STEP 2
Installing the Driver & Software
For Wireless Network Users
For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on page 4 - 11.
These instructions will install your Brother machine in
a typical small office or home wireless network
environment in infrastructure mode, using a wireless
router or access point that uses DHCP to assign IP
addresses.
If you want to setup your machine in any other
wireless environment you can find instructions in the
Network User's Guide on the CD-ROM.
You can view the Network User's Guide by following
the instructions below.
1 Turn on your Macintosh
CD-ROM labeled Macintosh
drive.
2 Double-click the Documentation icon.
3 Double-click your language folder.
4 Double-click the Network User's Guide
BH3eWLAN_UkEngNet.pdf.
To achieve optimum results with normal every day
document printing, place the Brother machine as
close to the network access point (router) as possible
with minimal obstructions. Large objects and walls
between the two devices as well as interference from
other electronic devices can affect the data transfer
speed of your documents.
First you must configure the wireless network settings
of your machine to communicate with your network
access point (router). After the machine is configured
to communicate with your access point computers on
your network will have access to the machine. To use
the machine from these computers, you will need to
install the MFL-Pro Suite Software. The following
steps will guide you through the configuration and
installation process.
34
®
X 10.2.4 or greater in infrastructure mode
®
. Insert the Brother
®
into your CD-ROM
1
Write down the wireless network settings of
your access point or wireless router.
SSID (Service Set ID or Network name)
_________________________
WEP Key (if needed)
_________________________
WPA-PSK (TKIP) (if needed)
_________________________
The WEP key is for 64bit encrypted networks
or 128 bit encrypted networks and can contain
both numbers and letters. If you do not know
this information you should see the
documentation provided with your access point
or wireless router. This key is a 64-bit or 128-bit
value that must be entered in an ASCII or
HEXADECIMAL format.
For example:
64 bit ASCII:
Uses 5 text characters.e.g. "Hello"
(this is case sensitive)
64 bit
Uses 10 digits of hexadecimal
Hexadecimal:
data.e.g. "71f2234aba"
128 bit ASCII:
Uses 13 text characters.e.g.
"Wirelesscomms" (this is case
sensitive)
128 bit
Uses 26 digits of hexadecimal
Hexadecimal:
data.e.g.
"71f2234ab56cd709e5412aa3ba"
WPA-PSK enables a Protected Access Pre-
shared key that allows the Brother wireless
machine to associate with access points using
TKIP encryption. WPA-PSK uses a Pre-Shared
Key that is more than 7 and less than 64
characters in length.
Note
• Your machine supports WEP and WPA-
PSK(TKIP). WPA-PSK(AES) is not supported.
• Most access points and routers can store more
than one key, but they will only use one at any time
for authentication and encryption.
See Chapter 3 of the Network User's Guide for
more details.
®
Macintosh