Brother MFC-8870DW Instrukcja połączenia - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja połączenia dla Faks Brother MFC-8870DW. Brother MFC-8870DW 4 stron. Vista network connection repair instructions
Również dla Brother MFC-8870DW: Podręcznik (7 strony), Instrukcja połączenia (5 strony)

Drukuj stronę

Brother MFC-8870DW Instrukcja połączenia

MFC8870DW Vista Network Connection Repair Instructions

a. On the Brother machine press MENU

b. Press 5 (PRINT REPORTS)

Press 6 (NETWORK CONFIG)

d. Press START. A network configuration report will print. Locate the IP address of your Brother

machine on this list. It will be displayed as XXX.XXX.XXX.XXX.

2. Obtain the computer's IP Address:

a. Press the WINDOWS/START button.

b. In the Start Search line type CMD and press ENTER.

On the command prompt line type IPCONFIG and press ENTER

d. Locate the line labeled IPv4 Address and note the IP address of the PC. If you do not receive an IP

address, this indicates that there is a problem with your computer's network connection. Try

restarting the computer, and completing PART 9 again. If you still do not receive an IP address

contact your router manufacturer or network administrator for support.

3. PING the Brother machine:

a. Press the WINDOWS/START button.

b. In the Start Search line type CMD and press ENTER.

Type: PING xxx.xxx.xxx.xxx (Where xxx.xxx.xxx.xxx is the Brother machine's IP Address

noted in PART 9-1.)

d. Press ENTER on your keyboard. The computer will ping, or try to communicate, with the

Brother machine. When completed, you will receive the PING STATISTICS.

e. If the number of packets sent DOES NOT equal the number of packets received, then there is

a communication problem between the Brother machine and the Computer. Attempt to

reestablish communication by completing the following steps:

Set boot method to Auto. This is necessary so that the Brother machine can attempt

to obtain a valid IP address from your router or access point.

ii.

On the Brother machine press MENU

iii.

Press 6 (LAN).

iv.

Press 2 (WLAN)

Press 1 (TCP/IP)

vi.

Press 1 (BOOT METHOD)

vii.

Scroll with the up or down arrow to AUTO and press OK. The LCD should display

ACCEPTED for a few seconds. Then press STOP/EXIT to return to the main LCD

screen.

viii.

Turn off the Brother machine, wait approximately 30 seconds and power the machine

back on. Complete PART 9 again.

If the number of packets sent equals the number of packets received, then this indicates

there is communication between the Brother machine and the Computer. Continue to the next

step.

g. On the command prompt line type: CONTROL PRINTERS. Press ENTER on your keyboard.

The Printers folder will open.

h. Right click on the Brother driver and left click on PROPERTIES. The Brother printer driver

properties screen will now appear.

4. Click the PORTS tab.

a. You will see a list of the available communication ports on your PC (Ex: LPT1:, LPT2:, COM1:,

ETC) Scroll down the list and you will see the current network port of your printer. Click on

CONFIGURE PORT.

b. When the CONFIGURE PORT screen appears compare the IP address or Node Name with the

IP address or Node Name listed on the network configuration page printed in PART 9-1. If you

receive an error and cannot configure the port, close the error and continue to STEP 4-k.