Fujitsu ScanPartner 15C Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Skaner Fujitsu ScanPartner 15C. Fujitsu ScanPartner 15C 23 stron. Image scanner
Również dla Fujitsu ScanPartner 15C: Specyfikacje (2 strony), Instrukcja aktualizacji (6 strony), Podręcznik użytkownika (26 strony), Instrukcje wymiany i czyszczenia materiałów eksploatacyjnych (7 strony), Procedury instalacji (5 strony)

2.1.2 Refitting the Shipping Bracket:

Whenever you need to move the Scanner to a new location it is advisable to

refit the shipping bracket to avoid causing damage to the Scanners' internal

mechanism. Please follow the instructions below to refit the shipping bracket.

i).

Turn off the Scanner power at the power on/off switch.

ii).

Open the document cover.

iii). Turn off the Scanner.

Note: For steps (iv) to (vi) please refer to figure 2-1 and 2-2

iv). Carefully place the Scanner in an upright position on its front side.

v).

Use a suitable screwdriver to remove the screw holding the shipping

bracket in the use position.

vi). Put the shipping bracket into the shipping position, with the long side

extending into the Scanner base. Secure it with the screw.

vii). Carefully place the Scanner back into its normal position.

When you have several devices on a SCSI chain, you may need to adjust

the SCSI ID selector setting located on the back of the Scanner. This setting assigns a

specific "device ID" to the Scanner. If the assignment conflicts with an existing SCSI

device, please select a new ID. (See Figure 2-3)

Note: The factory setting for Scanner is ID 6. Usually, ID 0 is assigned to an internal

hard disk drive, and ID 7, to SCSI adapter or host. ID 8 and 9 are not in actual

use.

Using a suitable tool, turn the selector switch until the arrow points to the desired ID

number.

2-3