■ Part No. and Replacement Cycle
for Carrier Sheet
One "Carrier Sheet" is provided with the scanner. If the
"Carrier Sheet" provided with the scanner can no longer
be used for scanning due to damage or wear-and-tear,
you can purchase a new Carrier Sheet separately.
The following table specifies the replacement number
and the standard replacement cycle for carrier sheets.
No. of
Part Name
Replacement Cycle
items
Carrier Sheet
5
After used for 500
(PA03360-0013)
scans
Contact your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider to obtain these prod-
ucts.
This replacement cycle is a rough guideline. This may
vary according to the type of documents scanned, scan-
ner usage, and cleaning frequency. If parts become
noticeably dirty, replace them accordingly.
Use only the PFU LIMITED parts
ATTENTION
specified. Do not use parts made by
other manufacturers.
The following diagram shows the Carrier Sheet.
For more details, refer to the "Operator's Guide".
■ Carrier Sheet
21
Appendix D
Network Connection Troubleshooting
■ Checking Basic Network Operation with a Ping Test
If a network connection is not possible, refer to "3.9 Checking the Network Connection" (page 10) for ping results and
how to deal with them.
Connection
Server name
Result
status
setting
"Ping statistics" shows
OK
IP address / host
"Lost=0 (0% loss)"
name / FQDN
"Ping statistics" shows
NG
IP address / host
"Lost=4 (100% loss)"
name / FQDN
IP Address
Host name /
FQDN
"Ping statistics" shows
NG
IP address / host
"Lost=N (1 to 99%
name / FQDN
loss)"
IP address / host
name / FQDN
"Hardware error"
NG
IP address / host
name / FQDN
"Ping request could
NG
Host name /
not find host
FQDN
xxxxxxxxx. Please
check the name and
try again."
OK: Connection is operating normally. NG: Connection is faulty.
Action
None
Check that the ping target IP address, host name, or
FQDN is correct.
If the ping target IP address is correct, refer to "Fail-
ure to Connect to a Server using its IP Address" (page
23) for further solutions.
On the "Network Status" screen, change [Link speed /
Duplex mode] from "Auto-Negotiation" to a fixed mode.
This can be changed as follows:
1.
Select the [Network Settings] tab on the top menu.
2.
Press the [
] button on the left side menu.
3.
Select the [Network Status] tab on the left side menu.
4.
On the "Network Status" screen, select [Link Speed/
Duplex Mode].
5.
Press the [OK] button.
There may be a problem with the quality of the LAN
cable. Replace the LAN cable and try again.
On the "Network Status" screen, change [Link speed /
Duplex mode] from "Auto-Negotiation" to a fixed mode.
This can be changed as follows:
1.
Select the [Network Settings] tab on the top menu.
2.
Press the [
] button on the left side menu.
3.
Select the [Network Status] tab on the left side menu.
4.
On the "Network Status" screen, select [Link Speed/
Duplex Mode].
5.
Press the [OK] button.
The LAN cable may have become disconnected dur-
ing the Ping test. Check the status of the LAN cable
and try again.
Check that the ping target host name or FQDN is cor-
rect.
Check that the DNS server or WINS server settings
are correct.
If the ping target host name or FQDN is correct, refer
to "Failure to Connect to a Server using its Host
Name or FQDN" (page 24) for further solutions.
22
Drukuj stronę