7. Check the scanned data.
8. Press the [OK] button.
The "Maintenance" screen is shown again.
■ If Scanning Completes
Successfully
Continue with the setting procedures described in Chap-
ter 1 of the "Operator's Guide".
To disable login with a guest
ATTENTION
account, select [Off] for "Guest
Account" in the [System Settings]
screen on the [Login Settings] tab.
System settings or user data can be
HINT
backed up from the [User Data Store]
or [System Settings File] screen on
the [Maintenance] tab. This can only
be performed via the network
interface. Backup should be per-
formed regularly. This can only be
performed via the network interface
using the Admin Tool or Central Admin
Console.
For more details, refer to the "Opera-
tor's Guide".
■ If Scanning does not Complete
Successfully
If the top cover is open
Message
Top cover may be open. Close the top cover,
reload the documents and try again.
Action
Close the top cover, and try the scan test again.
If no document is loaded
Message
Document not found. Load a document into the
ADF, making sure the side guides are adjusted
correctly and try again.
Action
Load a document, and try the scan test again.
If a multifeed is detected
Message
Feed Error: Document(s) may not match the set
paper size, ADF may have grabbed more than
one sheet, or documents may not be suitable for
scanning. Remove the documents from the ADF,
check them and try again. If problem persists,
consult the manual.
Action
Remove the document for which multifeed was
detected, and try the scan test again.
If a paper jam occurs
Message
Paper jam has occurred. Remove the documents
from the ADF and try again.
Action
If the "Scan Viewer" screen appears with par-
tially scanned data, just click the [OK] button.
Remove any unscanned documents from the
ADF. Open the scanner's top cover, remove the
jammed document from the scanner, and close
the scanner's top cover. From the "Maintenance"
screen, try the test scan again.
If a problem is detected with the scanner
Message
Scanner initialization has failed. Try turning the
power off and back on again. The administrator
should contact the FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider
for help.
Action
Try the following:
If the scanner does not restart automatically,
press the [Shutdown] button on the "Login"
screen to turn the power off, and turn the
power back on again to restart the scanner.
If the error status persists after the scanner is
restarted, press the [Shutdown] button on the
"Login" screen, disconnect the AC cable
from the scanner to turn the power off, wait
for at least 10 seconds, then reconnect the
AC cable and try turning the power back on
again. If the error status persists, contact
your FUJITSU scanner dealer or an
authorized FUJITSU scanner service
provider.
17
Drukuj stronę