Instructions for rack installation
CAUTION
•
When installing the ETERNUS DX60/DX80
Do Not
with other devices into the same rack, the air-
flow of the device installed on and under the
ETERNUS DX60/DX80 may interfere each
other and have a damaging effect on device
cooling. Make sure to leave plenty of room
between the devices if required. Failure to do
so may damage the ETERNUS DX60/DX80.
•
Especially for an enclosed rack with doors, or
Temperature
when multiple devices are to be mounted and
running, it's important to realize that the tem-
perature inside the cabinet will be consider-
a b l y h i g h e r t h a n t h a t o f t h e r o o m .
Consideration for clear air circulation should
be given to prevent the rack internal ambient
temperature from exceeding 40ºC. Failure to
do so, it may lead to damage the ETERNUS
DX60/DX80.
•
The ETERNUS DX60/DX80 weighs 35kg.
Do
When carrying the ETERNUS DX60/DX80,
two or more people should work together and
hold both sides and the bottom of the device.
Failing to do so may result in injury.
•
Be sure not to catch your fingers in the rack
when installing the ETERNUS DX60/DX80.
Doing so may result in injury.
•
When installing the ETERNUS DX60/DX80
into the rack, make sure to install from the bot-
tom to the top of the rack. If the bottom of the
rack is empty and the rack becomes unstable
it could both damage the ETERNUS DX60/
DX80 and cause injuries.
•
Install the blank panels provided with the rack
where no other devices are installed.
Copyright 2009 FUJITSU LIMITED
This manual uses recycled paper.
Handling cables
•
Do not damage or modify the power cable or
Do Not
the power plug such as heating, forced bend-
ing, twisting, pulling, or placing heavy objects
on them. Doing so will damage the cable and
lead to the ETERNUS DX60/DX80 malfunc-
tion.
•
Be careful not to bend or pinch the cable.
Doing so will damage the cable and lead to
the ETERNUS DX60/DX80 malfunction.
Do not bend square
•
Be sure to fully insert each cable connector
Do
into its socket. Not doing so may lead to mal-
function.
•
When inserting or removing the cable, be sure
to hold the plug, not the cable. Not doing so
may lead to damaging the ETERNUS DX60/
DX80 or malfunction.
•
Before connecting cables, confirm that the
connectors are clean and free of dust, oil, and
grease, etc. Not doing so may lead to mal-
function.
•
Keep a 30mm or larger radius when bending
the Fibre Channel cable. Bending or pinching
the cable will damage the cable and lead to
the ETERNUS DX60/DX80 malfunction.
30mm
or longer
ETERNUS DX60/DX80 Disk storage system
Safety Precautions
P3AM-3142-01EN
Date of issuance: June 2009
Issuance responsibility: FUJITSU LIMITED
Printed in Japan
•
The contents of this manual may be updated without notice.
•
While the contents of this manual are the product of all due care
and diligence, no responsibility can be accepted for operational
problems arising from any errors or missing information, or other
use of the information contained in this manual.
•
Fujitsu assumes no liability for damages to third party copyrights or
other rights arising from the use of any information in this manual.
•
Contents of this manual are not to be reproduced without permission
from Fujitsu.
•
Manuals with missing or wrongly collated pages will be replaced
free of charge.
90°
Do not bind up
Drukuj stronę