Fujitsu ETERNUS4000 400 Instrukcja połączenia z serwerem - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja połączenia z serwerem dla Przechowywanie Fujitsu ETERNUS4000 400. Fujitsu ETERNUS4000 400 32 stron. Disk storage systems (fibre channel) for oracle solaris
Również dla Fujitsu ETERNUS4000 400: Podręcznik (28 strony), Podręcznik (21 strony), Instrukcja połączenia z serwerem (25 strony), Instrukcja połączenia (19 strony)
Drukuj stronę
Chapter 3 Notes
>
3.5 MSCS and WSFC Notes
3.5
MSCS and WSFC Notes
•
To use MSCS or WSFC configuration, install the driver for ETERNUS Disk storage systems or
either the Windows Server® 2008 R2 or the Windows Server® 2008 standard multipath driver
(msdsm) on each node (server), and then check the connections before MSCS or WSFC
installation.
•
Check the registry values by following the instructions in
Information" (page
•
When setting up the MSCS, a reset group must be set for the ETERNUS Disk storage
system. A reset group does not need to be set for WSFC.
3.6
VERITAS Storage Foundation for Windows (SFW)
Notes
•
Installing VERITAS Storage Foundation for Windows
VERITAS Storage Foundation for Windows should be installed as specified in its accompany-
ing documentation.
•
VERITAS Device Driver Installation (DDI)
If the ETERNUS Disk storage systems are connected to a configuration that uses the VERI-
TAS Storage Foundation for Windows, the VERITAS DDI will also need to be installed.
Note that the VERITAS DDI must be installed after the VERITAS Storage Foundation for Win-
dows installation.
Refer to the Symantec web-site for VERITAS DDI installation details.
SFW 5.0 or later
SFW 5.1
SFW 5.1 SP1 or later
•
Checking the Load Balance Policy setting
For multipath configurations, make sure that "Round Robin(Active/Active)" is set for the Load
Balance Policy setting.
P3AM-2922-05ENZ0
ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for Windows®
26), after installing MSCS or WSFC.
SFW version
http://support.veritas.com/docs/326335
http://support.veritas.com/docs/326334
VERITAS DDI installation is not required.
•
In the "DSM Selection" window that appears during the VERITAS
DDI installation, select "FUJITSU ETERNUS 2000 Array" regardless
of the ETERNUS Disk storage system to be connected.
Only "FUJITSU ETERNUS 2000 Array" is displayed on the "DSM
Selection" window. Other ETERNUS Disk storage systems are not
displayed.
•
When VERITAS Storage Foundation for Windows 5.1 SP1 is newly
installed, VERITAS DDI installation is not required.
"Chapter 9 Checking the Registry
VERITAS DDI download URL
15
Copyright 2010 FUJITSU LIMITED