AEG PNC913123608 Podręcznik użytkownika - Strona 27

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz AEG PNC913123608. AEG PNC913123608 36 stron.

Drukuj stronę

13.2 Possible failures

Problem

The programme does

not start.

The appliance does not

fill with water properly.

The appliance fills with

water and drains immedi-

ately

The appliance does not

drain the water.

The spin phase does not

operate or the washing

cycle lasts longer than

usual.

There is water on the

floor.

Possible solution

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that the appliance lid and drum doors are closed

properly.

• Make sure that there is no damaged fuse in the fuse box.

• Make sure that the Start/Pause has been touched.

• If the delay start is set, cancel the setting or wait for the end

of countdown.

• Deactivate the Child Lock function if it is on.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the inlet hose has no kinks, damages or

bends.

• Make sure that the connection of the water inlet hose is

correct.

• Make sure that the filter of the inlet hose and the filter of

the valve are not clogged. Refer to 'Care and cleaning'.

• Make sure that the drain hose is in the correct position. The

hose may be positioned too low. Refer to "Installation in-

struction".

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Make sure that the connection of the drain hose is correct.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends

with water in the tub.

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the water inlet hose and the drain hose have

no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

ENGLISH