AEG FRIDGE-FREEZER Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka AEG FRIDGE-FREEZER. AEG FRIDGE-FREEZER 10 stron. Aeg fridge-freezer
Również dla AEG FRIDGE-FREEZER: Instrukcja obsługi (10 strony), Podręcznik użytkownika (28 strony)
Drukuj stronę
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18 C and +43 C (class T);
+18 C and +38 C (class ST); +16 C and +32 C (class
N); +10 C and +32 C (class SN).
The class of your appliance is shown on its rating plate.
For safety reasons, minimum ventilation must be as
shown in Fig. 1:
Appliance positioned under overhanging kitchen
wall units (see Fig. 1-A).
Appliance positioned without overhanging kitchen
units (see Fig. 1-B).
Attention: keep ventilation openings clear of obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
A
B
NP004
28
Fig. 1
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
PR153
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
Important
It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply
cable plug incorporates a special earth contact. If
the sockets of your domestic wiring system are not
earthed, have the appliance connected to a separate
earth wire by a qualified electrician in accordance
with existing safety regulations.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number 87/
308 of 2/6/87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as
these will damage the finish.
Fig. 2