Brother MFC 295CN - Color Inkjet - All-in-One Podręcznik szybkiej konfiguracji - Strona 29

Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Oprogramowanie Brother MFC 295CN - Color Inkjet - All-in-One. Brother MFC 295CN - Color Inkjet - All-in-One 43 stron. Digital copier printer

Drukuj stronę

For Wireless Network Users

Configure the wireless

settings using the

automatic wireless (one-

push) method

Confirm your wireless access point/router has

the SecureEasySetup™, Wi-Fi Protected

Setup or AOSS™ symbol as shown below.

Place the Brother machine within range of your

SecureEasySetup™, Wi-Fi Protected Setup or

AOSS™ access point/router. The range may

differ depending on your environment. Refer to

the instructions provided with your access

point/router.

Push the SecureEasySetup™, Wi-Fi Protected

Setup or AOSS™ button on your wireless

access point/router.

See the user's guide for your wireless access

point/router for instructions.

On your machine, press Menu.

Press a or b to choose 3.Network and press

OK.

Press a or b to choose 2.WLAN and press OK.

Press a or b to choose 3.SES/WPS/AOSS and

press OK.

When Change to WLAN? is displayed,

press a to accept.

This will start the wireless setup wizard.

This feature will automatically detect which

mode (SecureEasySetup™, Wi-Fi Protected

Setup or AOSS™) your access point uses to

configure your machine.

Note

If your wireless access point/router supports

Wi-Fi Protected Setup (PIN Method) and you

want to configure your machine using the PIN

(Personal Identification Number) Method, see

Using the PIN Method of Wi-Fi Protected Setup in

the Network User's Guide on the CD-ROM.

If the LCD shows Connected, the machine

has successfully connected to your wireless

access point/router. You can now use your

machine in a wireless network.

If the LCD shows Setting WLAN, then

Connection Error, a session overlap was

detected. The machine has detected 2 or more

wireless access points/routers on your network

that have the SecureEasySetup™, Wi-Fi

Protected Setup mode or AOSS™ mode

enabled. Make sure that only one wireless

access point/router has one of these modes

enabled and try starting from c again.

If the LCD shows Setting WLAN, then No

Access Point, the machine has not detected

the access point/router on your network with

the SecureEasySetup™, Wi-Fi Protected

Setup or AOSS™ mode enabled. Move your

machine close to the access point/router and

try starting from c again.

If the LCD shows Setting WLAN, then

Connection Fail, the machine has not

successfully connected to your wireless access

point/router. Try starting from c again. If the

same message is indicated again, reset the

machine back to the default factory settings

and try again. For resetting, see Restore the

network settings to factory default on page 41.

LCD messages when using the

SES/WPS/AOSS control panel menu

Searching for or accessing the

Setting WLAN

access point, and

downloading settings from the

access point.

Connecting to the access

Connecting

point.

SES/WPS/AOSS

The machine has successfully

Connected

connected.

A session overlap was

Connection

detected.

Error

The access point detection

No Access

failed.

Point

Connection failed.

Connection

The machine was not able to

Fail

connect with the access point.

Try the configuration from c on

page 29 again.

Note

You can also manually configure the wireless

settings following the steps starting at step 11-a

on page 26.

Press OK.