Fujitsu ScanPartner 620C Procedury instalacji - Strona 2

Przeglądaj online lub pobierz pdf Procedury instalacji dla Drukarka Fujitsu ScanPartner 620C. Fujitsu ScanPartner 620C 5 stron. Image scanner
Również dla Fujitsu ScanPartner 620C: Specyfikacje (2 strony), Podręcznik użytkownika (28 strony), Instrukcje wymiany i czyszczenia materiałów eksploatacyjnych (7 strony)

ScanPartner15C\600C\620C\93GX\3091DC\3092DC

Next connect the power cord to the scanner and a wall outlet, and then turn on the scanner.

The power, ready and paper jam LED will all light up, afterwards the scanner will complete its

self initialization and the paper jam light will go off in approximately 10 seconds. The SP93GX

power LED will flash and then go solid. The SP3091\3092DC's will flash a P, 0, and then 1.

Once this step is completed turn off the scanner and install the SCSI host adapter.

Step B: Installing the AVA2902E SCSI Host Adapter

1. Shut down your PC and remove the case cover.

2. Locate a free PCI slot and remove the back plate if necessary.

3. Install the SCSI controller in an open PCI slot.

Make sure that the card is seated completely in the slot and secured in the frame.

Warning! Failure to secure the SCSI controller in the PC can result in damage to the

SCSI card, scanner, and/or your system.

4. Next boot your PC without the scanner attached and go to device manager. The

SCSI controller will be listed as "aic78xx" and should be at IRQ 15 or lower and not

sharing its IRQ with any other device in the system.

Step C: Installing the SCSI drivers

1. When the New Hardware wizard comes up allow Windows to finish installing the files

for the SCSI controller.

2. Then go to www.adaptec.com, and click on the "search" tab. Scroll down to the

"Enter key word or quoted phrase" box and type in "aspi32.exe."

3. Next scroll down to the drivers section, click on "aspi32.exe" and follow the prompts

to download it to your desktop or a new folder.

4. Afterwards go to that location and double click on the "aspi32.exe" icon.

5. Follow the prompts.

6. Reboot and check for errors. If no errors shut down your system and go to the next

step.

Step D: Connecting the Scanner.

Warning ensure that the power is off when connecting or disconnecting any cables to the

scanner or workstation.

Setting the SCSI ID: The factory setting for the Scanner is 6, however, selecting a

different SCSI ID may be required when there are several devices on a SCSI chain.

Using a suitable tool, turn the selector switch until the arrow points to the desired ID

number (see figure 2-3). Setting the ScanPartner SCSI ID to 0, 1, or 7 is NOT

recommended as these settings are typically reserved for hard drives and the SCSI host

adapter.

Setting Termination: The Fujitsu ScanPartner comes complete with a built in SCSI

terminator (see Fig 2-3). If the Scanner is the last device in the SCSI chain, the

terminator should be switched to 'On'. If the Scanner is not the last device, the

terminator should be off.

Win95\98\ME Installation Procedure

Rev050404A