Fujitsu MB91460 SERIES Pierwsze kroki - Strona 31

Przeglądaj online lub pobierz pdf Pierwsze kroki dla Płyta główna Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 41 stron. 32-bit microcontroller
Również dla Fujitsu MB91460 SERIES: Podręcznik użytkownika (45 strony), Nota aplikacyjna (23 strony), Nota aplikacyjna (26 strony), Nota aplikacyjna (29 strony), Nota aplikacyjna (29 strony)

Getting Started

Chapter 6 Softune Workbench Getting Started

Figure 18: Debugging Mode after a successful Connection

Note that the interface has to be determined only once. Later you can choose the menu

Debug/Start debug to enter this mode.

6.7 Executing the Program

Now choose Debug/Run/Go, press F5 or click the

button. Look at the Starter Kit. A

"scrolling" LED has to be flashing on the Board.

To halt the execution, choose Debug/Abort or click the

button (Note, that this button is

only active in execution mode). The emulator system now is being halted. The execution can

be continued by entering the "Go"-Mode again.

To end the debugging just choose the menu Debug/End debug.

To save the project data choose File/Close Workspace.

Click "Yes". Afterwards you can close the Softune Workbench.

Note, that in the next start of the Workbench, your new LED-Project will occur in the menu

list File/Recent Workspace File. By simply clicking to "Led.wsp", the whole project will open

again.

- 31 -

MCU-AN-391005-E-V17