Fujitsu SK-8FX-TSC-32PMC Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Płyta główna Fujitsu SK-8FX-TSC-32PMC. Fujitsu SK-8FX-TSC-32PMC 28 stron.

1.3 General Description

The SK-8FX-TSC-32PMC is provided with a F

a LQFP32-M30 (PMC) package, as well as a FMA1125DC-24S Touch Sensor Controller

(TSC) in a 24-pin SSOP package.

It can be used as a stand-alone evaluation board or together with the MB2146-08-E BGMA

adapter.

1.3.1 Serial communication

The MB95F334 MCU offers two different USART peripherals for serial communication. The

UART/SIO offers full duplex, double buffered communication in asynchronous (UART) or

clock-synchronous (SIO) modes. The LIN-UART additionally implements the LIN protocol.

The serial interface connected to the on-board serial-to-USB converter can be selected by

solder jumpers JP16 and JP17. By default, the UART/SIO is used.

1.3.2 I2C Bus

In addition to the standard serial interfaces, the MB95F334 MCU also features an on-chip

I2C controller with a clock rate of 400kHz. Pull-up resistors (2.7kOhms) are provided on the

PCB. The I2C bus is also used for communication with the on-board Touch Sensor

Controller (TSC).

1.3.3 MCU Pins

All pins of the microcontroller are connected to standard 100mil (2.54mm) pin headers and

are directly available to the user. On-board peripheral circuits such as the TSC, LEDs and

USB can be disconnected by solder jumpers to free the corresponding MCU pins.

1.3.4 Power Supply

The SK-8FX-TSC-32PMC is by default powered by the USB connection to a host PC or USB

power supply. Alternatively, a stabilized supply voltage can be connected to the pin headers

X4 (GND) and X5 (VCC). JP3 must be opened in this case to disconnect the voltage

supplied by the USB connector X3.

1.3.5 Touch Sensor Controller FMA1125

The SK-8FX-TSC-32PMC can also serve as evaluation platform for the FMA1125 Touch

Sensor Controller. For this purpose, it offers several features:

< FMA1125DC-24S Touch Sensor Controller (SSOP24 package) with 4-8 touch input

channels and 4-8 digital I/Os (4 pins can be configured as I/O or touch input)

< Connector for up to eight touch input channels, with 'mini-slider' on PCB

< Four LEDs connected to TSC GPIO pins

The FMA1125 is connected to the MB95F334 MCU using the I2C bus. By default, the TSC is

using I2C address 0x68; alternatively it can be set to 0x69 using JP9.

1.3.6 User LEDs

The evaluation board offers several user LEDs. Eight LEDs are connected to the MCU, and

four additional LEDs are connected to the TSC GPIO pins. The LEDs can be disconnected

using solder jumpers to free the corresponding pins.

FMEMCU-UG-90003-10

SK-8FX-TSC-32PMC User Guide

Chapter 1 Overview

MC-8FX Flash microcontroller MB95F334 in

- 8 -