Fujitsu SK-96390-100PMC Podręcznik użytkownika - Strona 26
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Płyta główna Fujitsu SK-96390-100PMC. Fujitsu SK-96390-100PMC 32 stron. Mb96300 series
Drukuj stronę
4.1.3 Reset (optional)
Depending on the programming software a reset signal might be generated by RTS or DTR
line. In order to use this optional feature additional jumper have to be set:
Jumper
Programming
JP3
UART A
(DTR/RTS)
JP5
UART B
(DTR/RTS)
JP4
UART A or
UART B
(RESET A/B)
JP35
UART A or
UART B
(DTR / DTRx)
4.1.4 Flash Programming
1) Configure the microcontroller mode:
(Programming Mode)
2) Connect the configured UART (see above) to your serial PC communication port.
A straight 1:1 cable connection has to be used.
3) Start the tool "Fujitsu Flash MCU Programmer" software and make the settings:
Select Crystal
Open Source
(MHX-File)
Start
programming
UG-960017-11
SK-96390-100PMC User Guide
Chapter 4 Programming the internal Flash memory
Setting Description
UART
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
Table 4-3: Jumper Settings for reset signal
DIP-Switch S2
Set Device Type
MB96F395R/Y
4 MHz
Application.MHX
DTR signal of X3 is used as reset source
RTS signal of X3 is used as reset source
DTR signal of X5 is used as reset source
RTS signal of X5 is used as reset source
UART A (X3) is used to generate reset
UART B (X5) is used to generate reset
No negation for the DTR/RTS signal
DTR/RTS signal is negated
MD0 MD1 MD2 nc
ON
OFF
1
2
3
4
Select COM Port
- 26 -
© Fujitsu Microelectronics Europe GmbH