Fujitsu YOKOGAWA AF221 Nota aplikacyjna - Strona 9

Przeglądaj online lub pobierz pdf Nota aplikacyjna dla Płyta główna Fujitsu YOKOGAWA AF221. Fujitsu YOKOGAWA AF221 24 stron. Flash programmer - f2mc-16lx family 16-bit microcontroller all series

Drukuj stronę

4.4 Target Probe

The AF220/221 Flash Programmer uses a rare connector for connection to the target board:
DX31A-28P/DX-28-CV from Hirose Electric (www.hirose.com)
Figure 1-7: Pin Layout of
Target Probe Connector
Yokogawa offers optional three types of Probe Cables (Interface Cable). Depending on the
target board a cable with connector on both sides, with test clip on one side or a
simple cable has to be ordered:
Figure 1-9: Interface Cable AZ210
AF220 -
Signal Name
TRXD
TTXD
TCK
TAUX
-
TMODE
TAUX4
TAUX3
/TRES
/TICS
TVCC
VCC
GND
1,7,8, 14, 15, 21, 22, 28
*1
The used serial interface depends on the microcontroller series.
*2
Instead of P00, P01 other port-pins may be used
(See to Application-Note AN-MCU-390031-E-xx)
*3
The programmer signals (SINx, SOTx, SCKx, P00, P01, \RST) may conflict with the user-
system while programming. The signal /TICS can be used to disconnect the user circuit but additional three-state
drivers have to be used. Refer to the chapter "Examples of serial programming connection" of the MCU
hardwaremanual.
© Fujitsu Microelectronics Europe GmbH
FLASH PROGRAMMER YOKOGAWA AF220/221
Introduction
Figure 1-10: Interface Cable
AZ210 / AZ212
Pin No.
27
13
6
23
-
12
20
19
5
10
2
3
soldered on PCB
Table 1-1: Signal assignment of interface cable
Figure 1-8: Pin Layout of Target Probe
Connector viewed from cable side
Figure 1-11: Interface Cable AZ212
AZ211
AZ211
Pin No.
color
1
brown
2
red
12
white & red
9
white
-
-
4
yellow
11
white & brown
13
white & orange
14
white / yellow
8
grey
20
light blue
18
white & grey
(black)
- 9 -
Fujitsu-Name
*1
SOTx
*1
SINx
*1
SCKx
*2
P00
*2
P01
MD0
MD1
MD2
/RST
*3
optional
Vcc
Vcc
GND
MCU-AN-390087-E-V10