Indesit D41 Instrukcja instalacji i użytkowania - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji i użytkowania dla Zmywarka Indesit D41. Indesit D41 17 stron. Indesit dishwasher instruction for installation and use
Turning on the Appliance
Starting a wash cycle....
After having completed all of the installation steps in the
preceding paragraphs, turn on the water to the unit and
press the ON-OFF button (A) located on the control panel.
The "B" indicator light will come on. At this point, the
appliance is on and ready to be programmed.
Starting and selecting the cycle.
Turn the cycle selector knob "D" until the reference notch
on the knob corresponds with the number or the symbol for
the cycle you wish to set (have a look at the wash cycle table
on page 7).
After a few seconds, you will hear a short beep and the
indicator light "G" comes on, indicating that the wash cycle
has begun and it is not advisable to make any changes at
this point.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "G" which
come on in sequence as the appliance is performing that
specific phase of the wash cycle.
These phases are, from left to right:
pre-wash,
wash,
Cancelling or modifying a wash cycle in progress.....
Premise: You can cancel the wash cycle in progress, if it has
only just started.
To modify a wash cycle in progress, turn the knob anti-
clockwise and set it to Reset, after a few seconds you will
hear 4 beeps and indicator light "G" will go out: this means
all the settings have been cancelled. You are now free to re-
set the correct wash cycle.
GB
rinses,
drying
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the ON-OFF.
You can then load additional dishes and turn the appliance
back on. The cycle will start where it left off.
At the end of the wash cycle....
The end of the wash cycle is signalled by 2 short beeps and
a flashing drying phase indicator light "G". Set the knob to
the Reset position to clear all settings.
Turn the appliance off by pressing button "A", thus cutting
off the electricity supply.
Turn off the water tap.
Wait a few minutes before unloading the dishes: they are
very hot! If you wait a little while, they dry better thanks to
the steam.
Empty the lower rack first.
Make sure the wash cycle has ended before removing the
dishes!
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when you close the door.
Warning
If opening the door soon after the end of the programme,or
during it, stand away from the Dishwasher, to avoid possible
injury from hot steam.
6