Indesit DFG 0507 Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Indesit DFG 0507. Indesit DFG 0507 28 stron.

Drukuj stronę

To ensure floods do not occur, the dishwasher:

- is provided with a special system which blocks the

water supply in the event of anomalies or leaks from

inside the appliance.

Some models are also equipped with the supplementary

safety device New Acqua Stop

flooding protection even in the event of a supply hose

rupture.

Under no circumstance should the water inlet hose be

cut as it contains live electrical parts.

Before inserting the plug into the electrical socket, make

sure that:

The socket is earthed and complies with current

regulations.

The socket can withstand the maximum load of the

appliance, which is indicated on the data plate

located on the inside of the door (see chapter entitled

Description of the appliance).

The power supply voltage falls within the values

indicated on the data plate on the inside of the door.

The socket is compatible with the plug of the

appliance. If this is not the case, ask an authorised

technician to replace the plug (see Assistance); do

not use extension cables or multiple sockets.

Once the appliance has been installed, the power

supply cable and the electrical socket should be easily

accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be re-

placed by the manufacturer or its Technical Assistance

Service in order to prevent all potential hazards. (See As-

sistance)

The Company shall not be held responsible for any

incidents that occur if these regulations are not

observed.

, which guarantees anti-

After installing the dishwasher, open the door and stick

the adhesive transparent strip under the wooden shelf in

order to protect it from any condensation which may

form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately

before running the first wash cycle, completely fill the

salt dispenser with water and add only then

approximately 1 kg of salt (see chapter entitled Rinse aid

and refined salt). The water may overflow: this is normal

and is not a cause for concern. Select the water

hardness value (see chapter entitled Rinse aid and

refined salt). - After the salt has been poured into the

machine, the LOW SALT indicator light

If the salt container is not filled, the water softener

and the heating element may be damaged as a result.

Technical data

width 60 cm

Dimensions

height 85 cm

depth 60 cm

Capacity

12 standard place-settings

Water supply

0,05 ÷ 1MPa (0.5 ÷ 10 bar)

pressure

7,25 – 145 psi

Power supply

See appliance data plate

voltage

Total absorbed

See appliance data plate

power

Fuse

See appliance data plate

This dishwasher conforms to the

following European Community

Directives:

-2006/95/EC (Low Voltage)

-2004/108/EC (Electromagnetic

Compatibility)

-2005/32/EC (Comm. Reg.

1275/2008) (Ecodesign)

-97/17/EC (Labelling)

-2002/96/EC (Waste Electrical

and Electronic Equipment)

(WEEE)

Only available in selected models.

switches off.