Indesit LFT 114 UK Instrukcja serwisowa - Strona 23
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Zmywarka Indesit LFT 114 UK. Indesit LFT 114 UK 26 stron. Platform eos. built in
Drukuj stronę
Charging-and-discharging Pipe:
1.
Unfasten the 4 screws (2 on the front and 2 at the back) fixing the right hand side-panel and remove it.
2.
Turn the machine upside-down.
3.
Remove the basket by unhooking the "teeth" blocking the lower support fixing the pipes and pulling it out towards
the front part of the dishwasher.
4.
Insert a sharp-end screw-driver and attempt to unhook the wedge fixing the support fixing the pipes into place.
5.
Lift the cover and pull out.
6.
Pull out the discharge-pipe which has been positioned into place under pressure.
7.
Remove the tape fixing the charging pipe to the Airbreak and pull out.
Airbreak and Sweetener:
1.
Unfasten the 4 screws (2 on the front and 2 at the back) fixing the right-hand side-panel and remove it.
2.
Unfasten the metal-ring fixing the Airbreak to the dish-rack of the LVS.
3.
Pull out the connector from the Turbine Litre-count .
4.
Pull out the Airbreak.
5.
Remove the tape fixing the pipe onto the Airbreak.
6.
Unscrew the top and the metal-ring of the sweetener.
7.
Disconnect the the regenerating-valve and free the sweetener from the supporting-hook.
8.
Turn the sweetener by lifting it so that it can be removed sideways.
NB: Caution must be paid to the Airbreak Charging-pipe: it should be pushed towards the inside of the base in
order to prevent the sweetener to fall out.
9.
Disconnect the salt reading-module.
10.
Remove the tape fixed onto the water-collector sweetener.
11.
Remove the sweetener.
Water-Collector:
1.
Remove the filters and the lower rotor.
2.
Unscrew the 2 pipe support-screws for the upper drive in order to uncouple the parts.
3.
Unscrew the 4 screws on the water-collector metal-ring and extract.
4.
Turn the machine upside down and unhook the basket.
5.
Proceed with the dismantling the alternate washing-motor.
6.
Proceed with the dismantling of the electro-washing pump.
7.
Extract the discharging pipe and unscrew the discharging pump.
8.
Disconnect the conductivity sensor.
9.
Remove the NTC.
10.
Extract the water-collector.
Top Rotor Drive:
1.
Remove the racks.
2.
Remove the filters and lower rotor-drive
3.
Unscrew the 2 screws from the top rotor-drive pipe-support to uncouple the parts.
4.
With the aid of a flat-tipped screw free the top rotor-drive pipe-system .
Service Manual
Manual LFT 114 - 116 - 216
Edition
2007.10.15
23
Language
English