Indesit HOTPOINT LUCE DX1032CX Instrukcja serwisowa - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Piekarnik Indesit HOTPOINT LUCE DX1032CX. Indesit HOTPOINT LUCE DX1032CX 39 stron. Built-in touch control electronic multifunction 60 cm double oven
Drukuj stronę
Indesit
Company
d. The air gap at the rear allows the warmed air to pass out of the inner cabinet space but where
it is intended to fit cupboards above the oven unit it is essential that the warmed air is
exhausted through the front of the cabinet. Fig. 1 overleaf.
e. If an oven unit is installed adjacent to a tall cabinet, steam escaping from the oven when the
door is opened could condense on and perhaps stain the adjacent surface. To prevent
permanent staining the adjacent surface should be made of a material that is heat resisting and
easy to clean. Adjacent tall cabinets should not be deeper than the oven housing cabinet.
FINAL INSTALLATION
a. Using a spirit level, check that the housing cabinet is level from side to side and from front to
back in its installed position.
b. Correct any unevenness by placing spacers under the bottom of the cabinet. Make sure that
the cabinet rests firmly on the floor without rocking.
c.
Before the oven is fitted the cabinet must be firmly secured to the backing wall for stability.
d. The oven unit should now be lifted (requiring 2 people) into the cabinet and pushed fully home.
e. Finally the oven unit is secured to the cabinet by means of the four Pozi wash head screws, two
through each side trim.
f.
Remove all packing material from the grill and oven interior.
LOOSE ITEMS
4 x Phillips C/sk head 6 x 25 mm screws.
Service Manual UK
9 of 39
English