Indesit ID60C2 S Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kuchenki Indesit ID60C2 S. Indesit ID60C2 S 28 stron. Free standing electric cooker
Również dla Indesit ID60C2 S: Instrukcja obsługi (28 strony), Instrukcja instalacji i użytkowania (24 strony)

Drukuj stronę

Installation

WARNING - THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that

the voltage corresponds with your supply voltage, this

is stated on the rating plate, which is situated on the

outer rear panel.The model number and the serial

number are located on the front of the cooker, as

shown on the Features page.

The cooker must be connected by a competent

person such as one who is a, NICEIC registered

contractor to a suitable double-pole control unit with a

minimum rating of 32A and a minimum contact

clearance of 3mm (applicable to newer properties,

older properties where a 30A double pole control unit

and a minimum contact clearance of 3mm is

acceptable).

The double pole control unit should be fitted adjacent

to the cooker, in accordance with IEE regulations.The

control unit must be within 2 metres of but not directly

above the appliance and should be easily accessible

in the event of an emergency.

The power supply cable should conform to B.S.6004

with a conductor size of 6mm

Access to the mains terminals is gained by removing

the rear access cover. The mains cable must pass

through the cable clamp adjacent to the terminal

block. Sufficient cable should be used to allow the

cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from

any brackets affixed to the rear panel and is not

trapped to the rear wall when pushing the cooker

into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down

to set the height (900mm - 930mm) and level the

cooker.

The feet can be simply screwed in or out to lower or

raise the cooker.

After the correct height is achieved, lock the feet into

position by tightening the locking nut using an open

ended spanner.

CAUTION: Some soft floor coverings may get

damaged if the cooker is not moved carefully.

NOTE: Ensure oven shelves are level by using a spirit

level on the rod shelves.

, minimum.

Siting the Cooker

The cooker is designed to fit between kitchen

cabinets spaced 600mm apart.

The space either side need only be sufficient to allow

withdrawal of the cooker for servicing and cleaning. It

can be used with cabinets one side or both as well as

in an angled corner setting.

It can also be used freestanding.

Adjacent side walls which project above hob level,

must not be nearer to the cooker than 150mm and

should be protected by heat resistant material. Any

overhanging surface or cooker hood should not be

nearer than 650mm.

Note: This appliance must NOT be fitted on a

platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker

control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable

grip on the underside front edge of the oven roof,

avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding

suppression of radio and television interference.

Note: Take care in moving the cooker as it is

heavy.Take care to ensure that any floor covering

is not damaged.