Indesit KNJ3G2/UA Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kuchenki Indesit KNJ3G2/UA. Indesit KNJ3G2/UA 40 stron. Cooker and oven

Drukuj stronę

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring showing

the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired level

by turning the BURNER knob in an anticlockwise

direction. This may be the minimum setting C, the

maximum setting E or any position in between the two.

If the appliance is fitted with an electronic lighting

device* (see gure), press the ignition button, marked

with the symbol

hold the BURNER knob down

and turn it in an anticlockwise

direction, towards the

maximum flame setting, until

the burner is lit.

Several models are equipped

with an ignition device

which is built into the knob; in this case the electronic

ignition device* is present (C) but the ignition button

is not. Simply press the BURNER knob and turn it

in an anticlockwise direction so that it is pointing

to the maximum flame setting, until the burner is lit.

The burner may be extinguished when the knob is

released. If this occurs, repeat the operation, holding

the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off the

burner and wait for at least 1 minute before attempting

to relight it.

If the appliance is equipped with a flame failure safety

device*(X), press and hold the BURNER knob for

approximately 2-3 seconds to keep the flame alight

and to activate the device.

To switch the burner off, turn the knob until it reaches

the stop position •.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas consumed,

it is recommended that only pans that have a lid and

a flat base are used. They should also be suited to the

size of the burner.

To identify the type of burner, please refer to the

diagrams contained in the "Burner and nozzle

specifications".

Using the oven

! The first time you use your appliance, heat the empty

oven with its door closed at its maximum temperature

for at least half an hour. Ensure that the room is well

ventilated before switching the oven off and opening

the oven door. The appliance may emit a slightly

unpleasant odour caused by protective substances

used during the manufacturing process burning away.

, then

! Before operating the product, remove all plastic film

from the sides of the appliance.

! Never put objects directly on the bottom of the oven;

this will avoid the enamel coating being damaged.

Only use position 1 in the oven when cooking with the

rotisserie spit.

Lighting the oven

To light the oven burner, apply a lighted match or a

lighter to hole and while pressing in all the way set the

points to the notch.

For the minimum to maximum settings turn the knob

counter clockwise from "Off".

To turn off the burner, turn the knob clockwise until it

stops (corresponding again with setting •).

! The oven is fitted with a safety device and it is

therefore necessary to hold the OVEN control knob

down for approximately 6 seconds*.

! If the flame is accidentally extinguished, switch off the

burner and wait for at least 1 minute before attempting

to relight the oven.

Only available in certain models.

oven knob on maximum

The burner can be used at

maximum or intermediate

settings. These settings,

maximum

. and minimum

are indicated on the knob, plus

off, identified by the symbol •

and operative when this symbol