Indesit EcoTime IDVL 75 B R.9 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka Indesit EcoTime IDVL 75 B R.9. Indesit EcoTime IDVL 75 B R.9 16 stron.

Options

The options allow for customising the selected programme according to one's own needs.

Delay timer

The start of some programmes (see Programmes and options) may be delayed up to 9 hours. Press the button repeatedly to enter

the desired delay time. Before setting a delayed start, make sure that the filter is

clean.The drum will rotate occasionally before the

drying programme starts to prevent the formation of creases.

Post Anti-Crease

When this option is selected, the drum rotates garments at intervals after the COOL TUMBLE cycle has ended, in order to avoid

creases forming on garments if they cannot be immediately removed at the end of the programme. During this phase, the indicator

light is turned on.

Key Lock

Keep this button pressed for a few seconds after choosing the programme and the desired options. When the warning light is on,

the other buttons and the knob are deactivated. To deactivate the block keep the button pressed and the warning light goes off. The

ON/OFF button switches off the machine even if the function lock button is active.

Key Lock can be selected with all programs.

Light Drying

Light Drying is a special option designed to gentle dry delicate clothes.

Press this button to select the low temperature setting; the light next to the button will switch on. Activating this option will increase

the duration of the cycles

! Not all options are available on all programmes (see Programmes and options).

Opening the door

If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may

occur:

• The START/PAUSE button flashes orange.

• When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the

"Delay start" programme. One of the "Delay start" indicator light flashes to signal the delay time entered.

• It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running pha-

se and the START/PAUSE indicator light stops flashing and turns green.

• During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from

the beginning.

• By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This

procedure can be used to select the COOL TUMBLE programme to cool garments if they are judged to be dry enough.

Press the START/PAUSE button to start the new programme.

Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and

hold the ON/OFF button until the dryer reactivates, then press Start/Pause button.