AEG A 75310 GT Instrukcja obsługi i instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Zamrażarka AEG A 75310 GT. AEG A 75310 GT 20 stron. Chest freezers “ no frost”

The refrigerator or freezer needs air.

The side walls become warm whilst the appliance is on. The heat is generated by

the special refrigerating system (shell condenser) and prevents condensate and

thus rust from forming on the side walls. In order for the heat to be able to be

dissipated, air must be able to circulate around all the side walls.

Attention! To function correctly the appliance requires good ventilation. Make

sure that the side walls and the base of the appliance are not covered or

obstructed.

The appliance must have a solid, level footing. Please compensate for

uneven floors with appropriate supports.

Warning – this appliance must be earthed

Please ensure that the voltage and current indicated on the rating plate agree

with the voltage of your electricity supply.

220/240 volts (i. e. 220/240V AC).

If your appliance has been equipped with a mains lead with a moulded on type

plug, you must comply with the following regulations:

The plug moulded on to the cord incorporates a fuse. For replacement, use a 13

amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse

cover/carrier must be replaced in the event of changing the fuse. The plug must

not be used if the fuse cover/carrier ist lost. A replacement cover/carrier must be

obtained from an electrical goods retailer. If the socket outlets in your home are

not suitable for the plug fitted to the appliance, then the plug must be cut off and

an appropriate one fitted. When fitting the plug please note the following points:

Important

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

Blue

Brown

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings indentifying the terminals in

your plug, proceed as follows:

1. The wire which is coloured green and yellow must be connected to the earth

terminal in your plug, which is marked with the letter E or by the earth symbol

or coloured green, or green and yellow.

2. The wire which is coloured brown must be connected to the live terminal which

is marked with the letter L or coloured red.

Earth

Neutral

Live