AC-AUDIO Tube G52 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz AC-AUDIO Tube G52. AC-AUDIO Tube G52 11 stron. 2 channel tube preamp

3. INSTALLATION

The equipment is fitted with a 3-pin IEC connector which is approved internationally. A

mating socket with power cord and mains plug is supplied. Before connecting the unit to

the supply, check that the equipment is set for the correct mains voltage. The unit is set

for 110-120V 60Hz or 220-240V 50Hz operation internally, and should only be changed

by an authorized service centre.

The mains fuse required is 20mm anti-surge, 315mA rated at 250V. Sometimes, if it is

necessary to replace the fuse, please use the same type and rating only. The power

consumption of the equipment is 30VA.

Please note that attempted operation on the wrong voltage setting, or with an incorrect

fuse, will invalidate the warranty.

The microphone input is a via 3 pin female XLR connector, compatible for balanced

microphones.

The mating connector should be wired appropriately as the following way:

Balanced inputs:

Pin 1 = Ground (screen).

Pin 2 = Signal Phase (also known as "+" or "hot").

Pin 3 = Signal Non-Phase ("-" or "cold").

On the rear panel, every channel has a 3 pin TRS jack socket, which will accept

balanced or unbalanced line inputs providing the mating plug is wired suitably:

Balanced inputs:

Screen = Ground,

Tip = Signal Phase ("+" or "hot"),

Ring = Signal Non-Phase ("-" or "cold").

Unbalanced inputs:

Screen = Ground,