AEG 302D Instrukcja instalacji i obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Okap wentylacyjny AEG 302D. AEG 302D 19 stron. Aeg ventilation hood user manual

Installing the hood

to the wall

It is possible to fix the hood in position, if necessary, by only

attaching it to the rear wall.

Proceed as follows:

1. Drill the four holes on the wall as indicated (Fig. 11).

2. Insert the four rawl plugs supplied into these holes.

3. Screw the two mountings hooks into the top two rawl plugs

(Fig. 12).

4. Dismount the spacer M (Fig. 12) from the body of the hood by

unscrewing completely the two spacer fixing screws O and

washers.

5. Fix the base spacer M to the wall (Fig. 12) with the two screws

R 5x45 provided (Fig. 11) using either the long or the short arm,

depending on the depht of the side cupboards.

Do not tighten the screws fully.

6. Fix the hood to the wall by means of the two hooks P previously

mounted, but first move the upper brackets S (Fig. 11) so that

the front panel of the hood, once mounted, will be in line with

the front edge of the cupboard doors. The two upper brackets

S, located at the top rear edge of the hood may be slid

backwards and forwards by loosening its fixing screws T

adjacent to them on the upper hood surface (Fig. 11).

7. Check that the hood is at the right height. Minor height

adjustments may be made with the screws U embodied in the

brackets (see Fig. 11).

8. Tighten the two wall fixing screws R, through the two access

holes N provided on the inside of the hood (Fig. 12) then fix the

lower sliding frame to the hood with two screws O and washers

previously unscrewed (item 4).