A-Neuvideo EP-132 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów A-Neuvideo EP-132. A-Neuvideo EP-132 20 stron. Serial to ethernet converter

NEUVIDEO

Controller Updated

Factory Default Setting

By the chance, if you forget to setup password or have

incorrect settings making the converter inoperable, there

are two ways to reset setting and following procedures

can be used to reset all settings to factory default:

1. Turn off the power of converter.

2. Press the reset button of converter.

3. Turn on the power of converter and wait for 3 seconds.

4. The password will reset to the factory default (empty).

1. Log in the web page.

2. Press the reset button of converter.

3. Select the update button.

4. After Tx & Rx light flashing then unclasp the reset button.

5. The password will reset to the factory default (empty).

Web Console Configuration

(Figure 3.8)

Press "Update" Button After you finish the

detailed parameter setting. The converter

will save all parameters into internal non-

volatile memory and then reboot (see Figure

3.8). It takes about 5 seconds to complete

the whole process and new login page will

be presented (see Figure 3.1).

You can re-login and check if all parameters

have been correctly saved. If everything ok,

you can close the browser now.

Note : If domain of converter is different from

the computer running of browser, the login

page won't appear unless the converter's

"Gateway Address" has been correctly set.