A-Neuvideo ANI-HDR-100 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik A-Neuvideo ANI-HDR-100. A-Neuvideo ANI-HDR-100 12 stron. Hdmi 18gbps extender over cat5e/cat6 transmitter & receiver

Drukuj stronę

NEUVIDEO

Wideband IR (30KHz---60KHz) introduction

IR RECEIVER (RX):

• To control the source: Plug IR Receiver into the IR RX port of the receiver unit; place the receiver at or near the display.

• To control the display: Plug the IR Receiver into IR RX port of the transmitter unit; place the receiver in position where it is able to

receive remote signals.

IR BLASTER (TX):

• To control the source: Plug the IR Blaster into IR TX port of the transmitter unit; place the blaster in front of the IR eye of the source.

• To control the display: Plug the IR Blaster into IR TX port of the receiver unit; place the blaster in front of the IR eye of the display.

CONNECT & OPERATE