Kohler BELAY K-156T-LCP Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Armatura łazienkowa Kohler BELAY K-156T-LCP. Kohler BELAY K-156T-LCP 23 stron.

MAKE ELECTRICAL CONNECTIONS

WARNING: Risk of electric shock.

the power before performing the following

procedures.

WARNING: Risk of electric shock.

bathtub to properly grounded, grounding-type

power line protected by Residual Current Device

(RCD).

NOTICE:

1. A qualified electrician must install one RCD-

protected, 220 V, 30 A, grounded outlets for the

system. No other load should be on these circuits.

2. Equipotential position is near water pump bracket to

connect to the construction ground.

For corner installation or peninsular installation:

Select the corresponding side panel. If the side

panel on the side of the faucet is selected, the side

frame K-23771T (the options) should also be

selected.

Carefully install the gap panel in place, align the

side frame with the inner edge of the gap panel,

mark the position of the fixing holes on the wall,

remove the side frame, drill holes in the wall and

install the anchor, then install the side frame again

and tighten the screws. Apply the silicone sealant

into the gap between side frame and front apron.

1397340-T01-A

Disconnect

Connect

Heated Back

Heater

100%

Silicone Sealant

-10-

(RCD)

Power Input

220-240V

Air Pump

Water Pump

220 V 30 A

K-23771T(

Screw

Frame Side

RCD

)