Kohler K-1246 Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Armatura łazienkowa Kohler K-1246. Kohler K-1246 48 stron. Bath whirlpool
Również dla Kohler K-1246: Podręcznik właściciela domu (32 strony), Instrukcja uruchomienia (4 strony), Instrukcja uruchomienia (4 strony), Instrukcja instalacji (44 strony), Instrukcja instalacji (48 strony)

Drukuj stronę

Remove the Jets

Insert the tool hook as shown and pull the jet out of the

housing. The jet should be facing up when this is done.

14. Troubleshooting Procedure

Remove the Factory Installed Jets

NOTE: A special tool is provided with the replacement jets that will allow you to remove the jets from the

whirlpool. This tool is also supplied with each trim kit.

Position the jet ball nozzle so it is pointing upward.

NOTE: The nozzle must remain pointed up or the tool will slip off.

Insert the removal tool, hooked end up, into the opening of the jet and hook the inside top of the

nozzle.

Grasp the tool ﬁrmly and place your thumb against the whirlpool wall. Pull steadily on the tool

until the jet assembly pulls free of the hole. Be careful not to lose the O-ring.

Reinstall the Jets

NOTE: The jet O-ring must be correctly positioned, must be lubricated, and must be in good condition to

permit easy rotation and proper operation of the jet.

Install the O-ring onto the ﬁrst shoulder of the jet. Lubricate the O-ring with silicone lubricant to

prevent noisy operation of the jet.

Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into

position. Do not force the jet.

NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.

Troubleshooting Guide

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Symptoms

1. Whirlpool does not start or

stop.

1055820-2-A

Probable Causes

A. No power to motor.

B. Air actuator does not work.

C. Air actuator tubing is

disconnected, loose, kinked,

plugged, or damaged.

D. Motor/pump does not work.

Reinstall the Jets

Housing

Slide the O-ring

onto the first

shoulder of the jet.

Insert the jet into the housing, and lightly

push and rotate until it snaps in position.

Recommended Action

A. Set/reset the GFCI or ELCB;

check wiring.

B. Replace air actuator.

C. Connect, straighten, clean, or

replace air actuator tubing.

D. Rebuild or replace

motor/pump.

Inspect and

lubricate the O-ring.

Kohler Co.