AEG LAVATHERM T37800 Instrukcja obsługi - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka AEG LAVATHERM T37800. AEG LAVATHERM T37800 29 stron. Exhaust air dryer

Adjusting the level of conductivity

Water contains, a variable quantity of limestone and mineral salts of

which quantities vary according to geographical locations thus vary-

ing its conductivity values.

Relevant variations of the conductivity of the water compared to

those prefixed by the factory could slightly influence the residual

humidity of the laundry at the end of the cycle.

Your dryer allows you to regulate the sensitivity of the drying sensor based on

conductivity values of the water by using the following procedure.

Procedure:

Turn the programme selector dial to switch on the appliance

In selection mode press simultaneously the buttons 3 and 6 until «

appears on the digits.

Adjusting the level of conductivity:

Press the button 5 sequentially: the level of conductivity is indicated

by the lighting of the horizontal hyphens.

DISPLAY

C C 0 0 - -

Normally, the appliance is factory-set to the highest level; howe-

ver, certain models may be configured differently.

Memorizing the new setting:

Simultaneously press down the buttons 3 and 6 until the previous

drying cycle time appears again on the display and the buzzer sounds.

Conductivity degree

Low

Medium

- -

- - - -

High

Approximative value

µS/cm (25°C)

< 300

300 - 600

> 600

C C 0 0