AEG TR832W84G Podręcznik użytkownika - Strona 24

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Suszarka AEG TR832W84G. AEG TR832W84G 36 stron.

Drukuj stronę

www.aeg.com

Error code

EH0

If the display shows other error codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible

solutions.

11.2 Troubleshooting

Problem

The tumble dry‐

er does not op‐

erate.

Unsatisfactory

drying result.

Possible cause

The mains supply is unstable.

Possible cause

The tumble dryer is not connected

to the mains supply.

The door is open.

The On/Off button was not pushed. Push the On/Off button.

The Start/Pause button was not

touched.

The appliance is in standby mode.

Incorrect programme selection.

The filter is clogged.

Dryness Level option was set to

Iron Dry .

The load was too large.

The airflow slots are clogged.

There is some dirt on the humidity

sensor in the drum.

The dryness level was not set to

the desired level.

The condenser is clogged.

Remedy

When the appliance is showing

EH0, please wait until main supply

is stable than press start. If the ap‐

pliance pause the cycle without

any indication then press the cycle

start. If the warning will occur

check the power cord / socket in‐

tegrity or main supply.

Remedy

Connect it to the mains socket.

Check the fuse in the fuse box (do‐

mestic installation).

Close the door.

Touch the Start/Pause button.

Push the On/Off button.

Select a suitable programme.

Clean the filter.

Change Dryness Level option to a

higher level.

Do not exceed the maximum load

size.

Clean the airflow slots at the bot‐

tom of the appliance.

Clean the front surface of the

drum.

Adjust the dryness level.

Clean the condenser.