Kohler Sonata K-1677 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Armatura łazienkowa Kohler Sonata K-1677. Kohler Sonata K-1677 17 stron. Acrylic shower modules

Drukuj stronę

Install water-resistant

wall material so the

paperbound edge is at

least 1/4" (6mm)

above the finished,

concave surface of the

module

4. Complete the Finished Wall

- If you have not already done so, carefully remove the protective tape from the module surfaces.

- Cover the framing with water resistant wall material so the paperbound edges are within 1/4" (6mm) of the

finished, concave surface of the module. Seal the joints between the module edges and the water resistant wall

material with silicone sealant.

- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal

the joints between the module rim and the finished wall material with silicone sealant.

5. Complete the Installation

- Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory manufacturer's

instructions.

- Install the shower door according to the manufacturer's instructions.

6. Clean-up After Installation

- When cleaning up after installation, do not use abrasive cleansers as they may scratch and dull the surface. Use

warm water and a liquid, non abrasive detergent to clean the surface.

- Remove stubborn stains, paint, or tar with turpentine or paint thinner.

- Do not allow cleaners containing petroleum distillates to remain in contact with the module surface for any length

of time.

- Remove plaster by scraping with a wood edge. Do not use metal or wire tools. Use a powder type detergent on a

damp cloth to provide mild abrasive action to the residual plaster.

Kohler Co.

Å Å Å Å Å Å Å Å Å

Concave Surface

Stud

Furring

Strip

Apply a

continuous bead

of silicone sealant

to the nailing-in

flanges

1013850-2-