Kohler BLISS K-17270T-GR Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wanny Kohler BLISS K-17270T-GR. Kohler BLISS K-17270T-GR 9 stron. Enameled cast iron bath

Use 25~30 Kg dry cement and sand mix. Add water to

make a paste mortar. Remove the tub. Cover the

installation area with the mortar starting from the middle

of the tub as shown. The height of the mortar should

reach the bottom of the tub.

NOTE:

DO NOT CLOG THE DRAIN HOLE.

Place the tub onto the mortar. Insert the drain tailpiece

into the trap.

Make sure that the bottom of the tub is pressed into

mortar in order to secure the tub. Insert two wood

wedges under the tub to support the weight of the tub

until the mortar hardens. (Wedges will remain in the

mortar.) Frequently check the level of the tub.

25~30

B. Install Plumbing

CAUTION: Risk of damage to bath bottom and subfloor.

Ensure a watertight seal on the bath drain connections.

. For through the floor drain installation, when the

bath is securely positioned, connect the drain to the

trap. See fig. A.

2). Install the faucet valving and spout tee. Open the

hot and cold water valves, and check the supply

connections for leaks.

. Run water into the bath, and check the drain

connections for leaks.

1).

2).

3).

1046553-T01-B

Drain Hole

Level

Paste Mortar

Middle of Bath

Wood Wedge