Kohler System II K-809 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wanny Kohler System II K-809. Kohler System II K-809 28 stron. Drop-in bath whirpool

Kohler System II K-809 Instrukcja instalacji
Press the "Jets"
button to turn on and
off the whirlpool
functions

11. Confirm Proper Operation

Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
- Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.
- Fill the whirlpool to a water level at least 2" (5cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104_F (40_C).
Operating Sequence
NOTE: A built in heater automatically maintains the water temperature when the whirlpool is running.
- Press the Jets" button to turn on the whirlpool at high speed.
- Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Press the Jets" button again to run the whirlpool at low speed.
- Press the Jets" button a third time to turn off the whirlpool.
NOTE: A built in timer automatically stops the whirlpool after approximately 20 minutes of operation.
Kohler Co.
Turn the jet trim
ring clockwise to
decrease the flow
9
Turn the jet trim ring
counterclockwise to
increase the flow
1011606-2-
B