Kohler Escale K-23077T-CPS Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Toalety Kohler Escale K-23077T-CPS. Kohler Escale K-23077T-CPS 23 stron. Floor standing toilet
Również dla Kohler Escale K-23077T-CPS: Instrukcja instalacji (11 strony), Instrukcja instalacji (28 strony)
Drukuj stronę
Notice: a. Because the installation position of the
sensor will affect directly to the future
operation of the sensor, you are
recommended to confirm the correction
position of the sensor after its placement
and fix it.
b. Don't mistake the direction of inlet and
outlet.
c. Don't drop the O-rings.
d. Keep the wire plug-in away from water.
e. Align the center of the flushing valve with
the center of the toilets/squats, and ensure
it parallel with the wall, or will result in the
false operation of the sensor.
f. Do not use any sealant or grease on the
valve or connector and outlet pipe.
g. While more than 3 sets of sensor were
installed in one lavatory, the inner diameter
of main inlet pipe should not be less than
38mm.
h. Do not connect the DC output of AC Power
unit to AC power supply.
i. Do not connect to power supply while
installing. Connection line is not supplied.
AC connection wire with insulating sleeving
is recommended. Wire of which the nominal
section area of conductor is not less than
2
0.5mm is also recommended. DC
connection line use wire of which the
nominal section area is not less than
2
0.3mm . It is cut according to acted
installation requirements(The length of cut
wire is recommended less than 10m).
j. The head AC power supply must be
protected with appropriate fuse.
k. Please confirm the AC power supply and
water supply should be shut off before
maintaining the products with AC power
related.
1350669-T01-A
注意:
因为感应器的安装位置将对感应器的工作
a.
产生直接影响，要求放置后经测量确认感
应器位置准确无误后再固定。
不要将进出水方向弄错。
b.
不要将密封圈丢失。
c.
不要让接插件受潮。
d.
冲洗阀中心要求与座/蹲便器中心对齐并保
e.
证与墙面平行，否则将可能引起误动作。
不要在阀体部件或接头和出水配管上使用
f.
任何密封胶或油脂。
g.
当一个卫生间同时安装3台以上感应器时推
荐主供水管内径大于38mm。
不可将交流电源盒的直流输出端与交流电
h.
连接。
安装时不要向电源盒供电。连接线请用户
i.
自备，建议交流电源线采用导体标称截面
2
积 0.5mm 的电线，直流连接线采用导体
标称截面积 0.3mm 的电线，电线长度根
据实际安装需要自行裁剪（建议连接线长
度小于10m)。
交流电的总电源必须有合适的熔断丝加以
j.
保护。
维修时必须断开交流电源并关闭水源。
k.
2
6