Kohler Command CH13 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Silnik Kohler Command CH13. Kohler Command CH13 17 stron. Horizontal crankshaft
![Kohler Command CH13 Instrukcja obsługi](/uploads/products/server2/2635043/2635043.jpg)
- 1. Safety Precautions
- 2. California Proposition 65 Warning
- 3. Oil Recommendations
- 4. Oil Type
- 5. Fuel Recommendations
- 6. Cold Weather Starting Hints
- 7. Maintenance Instructions
- 8. Maintenance Schedule
- 9. Change Oil and Oil Filter
- 10. Oil Sentry
- 11. Carburetor Troubleshooting and Adjustments
- 12. Troubleshooting
- 13. Specifications
- 14. Parts Ordering
- 15. Major Repair
- 16. Model Designation
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table. They should also
be included as part of any seasonal tune-up.
Frequency
Daily or Before
Starting Engine
Every 25 Hours
Every 50 Hours
Every 100 Hours
Every 200 Hours
Annually or
Every 500 Hours
¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
2
Only required for Denso starters. Not necessary on Delco starters. Have a Kohler Engine Service Dealer perform
this service.
Check Oil Level
The importance of checking and maintaining the proper
oil level in the crankcase cannot be overemphasized.
Check oil BEFORE EACH USE as follows:
1. Make sure the engine is stopped, level, and is cool
so the oil has had time to drain into the sump.
2. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil fill cap/
dipstick before removing it.
3. Remove the oil fill cap/dipstick; wipe oil off.
For engines with a press-on style dipstick:
Reinsert the dipstick into the tube and press onto
the tube. See Figure 6.
For engines with a thread-on style dipstick:
Reinsert the dipstick into the tube and rest the oil
fill cap on the tube. Do not thread the cap onto the
tube. See Figure 6.
Press-On
Figure 6. Dipstick Styles.
8
Maintenance Required
• Fill fuel tank.
• Check oil level.
• Check air cleaner for dirty¹, loose, or damaged parts.
• Check air intake and cooling areas, clean as necessary¹.
• Service precleaner element¹.
• Check gear reduction unit.
• Replace air cleaner element¹.
• Change oil.
• Remove cooling shrouds and clean cooling areas¹.
• Change oil filter.
• Check spark plug condition and gap.
• Replace fuel filter.
• Have bendix starter drive serviced².
• Have solenoid shift starter disassembled and cleaned
Thread-On
2
.
4. Remove the dipstick and check the oil level.
The oil level should be up to, but not over, the "F"
mark on the dipstick. See Figure 7.
Operating
Range
Figure 7. Oil Level Dipstick.
5. If the level is low, add oil of the proper type, up to
the "F" mark on the dipstick. (Refer to "Oil Type" on
page 4.) Always check the level with the dipstick
before adding more oil.
NOTE: To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the "L"
mark or over the "F" mark on the dipstick.
"F" Mark