Kohler Command CV750 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Silnik Kohler Command CV750. Kohler Command CV750 25 stron. Vertical crankshaft engine
Również dla Kohler Command CV750: Instrukcja obsługi (8 strony), Instrukcja obsługi (24 strony)

Drukuj stronę

If the battery charge is not sufficient to crank the

engine, recharge the battery (see page 14).

Operating

Angle of Operation

This engine will operate continuously at angles up to

25°. Check oil level to assure crankcase oil level is at

the "FULL" mark on the dipstick.

Refer to the operating instructions of the equipment

this engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously at

angles exceeding 25° in any direction. Engine

damage could result from insufficient

lubrication.

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the

customers expense, may be performed by any non-road engine repair establishment or individual. Warranty

repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable

the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should

also be included as part of any seasonal tune-up.

Frequency

Daily Or Before

Starting Engine

Every 25 Hours

Every 100 Hours

Every 200 Hours

Every 250 Hours

Annually or

Every 500 Hours

Every 1500 Hours

Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.

Only required for Denso starters. Not necessary on Delco starters. Have a Kohler Engine Service Dealer perform these services.

Cleanout kits 25 755 20-S (black) or 25 755 21-S (gold) allow cooling areas to be cleaned without removing shrouds.

Maintenance Instructions

Maintenance Required

• Fill fuel tank.

• Check oil level.

• Check air cleaner for dirty

• Check air intake and cooling areas, clean as necessary

• Service precleaner element

• Replace air cleaner element

• Change oil (more frequently under severe conditions).

• Remove cooling shrouds and clean cooling areas

• Check oil cooler fins, clean as necessary (if equipped).

• Change oil filter.

• Check spark plug condition and gap.

• Replace fuel filter (Carbureted engines).

• Replace heavy-duty air cleaner element and check inner element

• Have bendix starter drive serviced

• Have solenoid shift starter disassembled and cleaned

• Replace fuel filter

(EFI engines).

Cooling

NOTE: If debris builds up on the grass screen or

other cooling areas, stop the engine

immediately and clean. Operating the engine

with blocked or dirty air intake and cooling

areas can cause extensive damage due to

overheating. See Clean Air Intake/Cooling

Area, page 13.

WARNING: Hot Parts!

Engine components can get extremely hot from operation. To

prevent severe burns, do not touch these areas while the engine

is running, or immediately after it is turned off. Never operate

the engine with heat shields or guards removed.

Engine Speed

NOTE: Do not tamper with the governor setting to

increase the maximum engine speed.

Overspeed is hazardous and will void the

engine warranty. The maximum allowable

high idle speed for these engines is 3750 RPM,

no load.

, loose, or damaged parts.

1,3