Kohler 10ERG Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator Kohler 10ERG. Kohler 10ERG 48 stron. Commercial mobile generator set

Drukuj stronę

2.4 Advanced Digital Control

Operation

Figure 2-2 illustrates the user interface on the Advanced

Digital Control (ADC 2100).

Note: Have setup and adjustments of the ADC 2100

performed only by an authorized Kohler

distributor/dealer. The setup and adjustments

are password protected.

1. LED display

2. Up and down arrow buttons (use for setup and adjustment

only)

3. Generator set master switch

4. Select button (use for setup and adjustment only)

Figure 2-2 ADC 2100 Control

Control or Indicator

Item

Runtime hours

LED display

p y

Crank indication

Fault codes

Software version

Keypad

Select and arrow

buttons

Generator set master

Three-position

switch

Figure 2-3 ADC 2100 Controls and Indicators

4 Operation

GM28707A-C

Description

Displays total generator set runtime hours.

Displays CC_1, CC_2, or CC_3 to indicate the first, second or third attempt to start the

engine. The last digit flashes during the crank cycle rest periods.

Flashes a 2- or 3-letter fault code to indicate various fault conditions. See Section 2.4.4.

See TP-6335, Generator Set Installation Manual.

The keypad is used for controller setup and adjustment only. Have setup and adjustments

performed only by an authorized distributor/dealer. The setup and adjustment functions are

password-protected.

Switch functions as the generator set operation and controller reset switch.

2.4.1

Controls and Indicators

Figure 2-3 describes the controls and indicators located

on the controller. The LED display indicates generator set

status as shown in Figure 2-3. The display is active when

the master switch is in the RUN or AUTO position and

remains active until the generator set master switch is

moved to the OFF/RESET position or the power to the

controller is removed. If the factory-installed continuous

power mode jumper has been disconnected, the LED

display turns off 48 hours after the generator set

shutdown. See Section 2.4.6.

The buttons on the controller keypad are used only for

system configuration and adjustment. The controller is

factory-set and should not require configuration or

adjustment under normal operating conditions. If the

generator set is reconnected to a different voltage

and/or frequency, refer to an authorized Kohler

distributor/dealer

for

adjustment instructions.

system

configuration

TP-6334

and

9/04