Kohler 17RESL Instrukcja instalacji - Strona 23

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przenośny generator Kohler 17RESL. Kohler 17RESL 40 stron. Residential/commercial generator sets
Również dla Kohler 17RESL: Działanie (48 strony)

Drukuj stronę

17/18 kW

1. Junction box

2. Field connection terminal block location (see Figure 1-20)

3. Suggested electrical inlet

Figure 1-19 Field Wiring

Figure 1-20 Field-Connection Terminal Block

TP-6516 4/09

12 kW

ADV-7466

ADV-7341

1.8.2

Remote Start Connection

Connect engine start leads from terminals 3 and 4 to the

automatic transfer switch's engine start terminals or to

an optional remote start/stop switch. Route the engine

start leads through separate conduit from the AC power

and load leads.

1.8.3

Grounding

Ground the generator set. The grounding method must

comply with NEC and local codes.

grounding strap to the generator set ground lug,

terminal GND inside the controller compartment.

Kohler generator sets are shipped with the generator

neutral attached to the generator in the junction box. At

installation, the neutral can be grounded at the

generator set or lifted from the ground stud and isolated

if the installation requires an ungrounded neutral

connection at the generator. The generator set will

operate properly with the neutral either bonded to

ground or isolated from ground at the generator.

Various regulations and site configurations including the

National Electrical Code (NEC), local codes, and the

type of transfer switch used in the application determine

the grounding of the neutral at the generator. NEC 2002

Section 250.20 is one example that has a very good

explanation of the neutral grounding requirements for

generators.

1.8.4

Battery Charger

A 6-amp battery charger is factory-installed in the

battery compartment to keep the starting battery fully

charged. The battery charger's DC leads are factory-

connected.

Plug the battery charger's power cord into the

receptacle on the bottom of the controller junction box.

Refer to the generator set Operation Manual for battery

charger operation information.

Connect the

Section 1 Installation